The Brew Cabin

Posted: **Fri May 23, 2008 9:58 am**

LLL, agree with time in motion.
Whats the shop in luton called? Dick Turpin's? thats robbery.
I think i will open a shop in luton if thats the kind of prices you pay down there.
Â£24 a lengh and Â£5 a bend is a bit on the dear side to me.

Posted: **Sat May 24, 2008 3:29 pm**

LLL FLO. I like timesaver, ensign, high density polyethylene ( hdpe ) because they are longer lengths, easy to lay, no pushing home the joints hoping the rubbers stay in, less chance of leakage. Just use a ratchet spanner, or hot welded joints. V Js are great to especially where there will be thrust IE water main, rising main etc. :;):

Posted: **Sat May 24, 2008 9:07 pm**

it would be a terrible abuse of my position to tell you it was shefford building supplies,that charged me so much for this 1 piece of plastic,so i wont
LLL :;):

The Brew Cabin

Mixing manufacturers