Garage
-
- Site Admin
- Posts: 1854
- Joined: Tue Aug 19, 2008 7:03 pm
- Location: kings lynn norfolk
- Contact:
Scottish building regs. could be different from england, might be worth asking local builders what is done in the area, by the way i'm looking for any work at mo. rab MSH
paving, mini-crusher, mini-digger hire and groundwork
http://mshpaving.co.uk
http://mshpaving.co.uk
-
- Posts: 1328
- Joined: Thu Mar 26, 2009 9:00 am
- Location: Warwickshire
- Contact:
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire
all founds must be 1 m minimum below existing ground level
if a machine does them a 450 bucket is wide enough for a cavity wall plus overhang
most garages are single skin as they are purely for storage,so 2300 opening for the door and 2 piers at the front of 335mm or 450 mm
slab should be min 100mm thick concrete on type1
flat roof is fine
on a budget i reckon you could do a single garage for 3.5-4k
that is doing nearly all the ground work yourself
LLL
if a machine does them a 450 bucket is wide enough for a cavity wall plus overhang
most garages are single skin as they are purely for storage,so 2300 opening for the door and 2 piers at the front of 335mm or 450 mm
slab should be min 100mm thick concrete on type1
flat roof is fine
on a budget i reckon you could do a single garage for 3.5-4k
that is doing nearly all the ground work yourself
LLL
-
- Posts: 1568
- Joined: Mon May 10, 2010 9:58 pm
- Location: Gatwick
- Contact:
If theres no trees build it on a raft rather than strip foundation, thats your foundations and floor poured in one go. As the rest have said insulation is key nowt worse than a garage thats cold and mildew etc gets on everything. If its budget, timber frame and clad on maybe 4 course of brick? Insulate then plasterboard
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire
-
- Posts: 1869
- Joined: Sun Jun 07, 2009 10:19 pm
- Location: scotland
my budget is around the 3k mark but i can do 90% of the work myself. was planning on hand digging the found etc and doing everything bar laying the bricks (rather not practise/learn on my own build). flat roof with felt, cutter connected to existing storm drain etc. its purely for storage of tools etc but would prefer double skin insulated but not essential.
God loves a tryer
-
- Site Admin
- Posts: 4420
- Joined: Sat Aug 09, 2008 3:55 pm
- Location: high peak
- Contact:
theres a spec on the main site for a garage slab with toe beam......
Giles
Groundworks and Equestrian specialists, prestige new builds and sports pitches. High Peak, Cheshire, South Yorkshire area.
http://www.gbgroundworks.com
Groundworks and Equestrian specialists, prestige new builds and sports pitches. High Peak, Cheshire, South Yorkshire area.
http://www.gbgroundworks.com
-
- Site Admin
- Posts: 8346
- Joined: Mon Jul 05, 2004 7:27 pm
- Location: Warrington, People's Republic of South Lancashire
- Contact:
There is! It's here
I'm going to have to get around to updating all these drawings at some stage. They keep bloody changing the nomenclature used for concrete.
I'm going to have to get around to updating all these drawings at some stage. They keep bloody changing the nomenclature used for concrete.
Site Agent - Pavingexpert
-
- Posts: 521
- Joined: Wed Feb 22, 2012 9:38 pm
It depends what you need it for. For just general storage and you don;t mind a little damp then a single skin on a raft is fine.
If its going to store lots of expensive tools, motorbike etc then assuming your doing it yourself i would definatly go for a normal strip footing with a cavity wall. It will work out a decent bit dearer but I am a little against garages on rafts as i have been asked so many times by people how to stop water coming into the base of the wall. i.e the 2 courses below dpc
The wall to floor junction on a raft is very hard to waterproof effectively, so if you have any kind of higher ground on one side then don't go for a raft.
If its going to store lots of expensive tools, motorbike etc then assuming your doing it yourself i would definatly go for a normal strip footing with a cavity wall. It will work out a decent bit dearer but I am a little against garages on rafts as i have been asked so many times by people how to stop water coming into the base of the wall. i.e the 2 courses below dpc
The wall to floor junction on a raft is very hard to waterproof effectively, so if you have any kind of higher ground on one side then don't go for a raft.