Rodding access covers in manholes - How to fit access covers

tomhoban · Post: # 69882Post **tomhoban** Mon Oct 31, 2011 3:30 pm

Hello all

If I could pick your brains on "Dauntless" galvanised rodding access covers. We have completed several backdrops, we got the rodding access covers in at the time but decided to leave the fitting of these to the end. The rodding pipes stick into the manholes by about 100mm. The frame of the cover does not fit inside the pipe and I can't see how they go together.Have we got the right item to fit to supersleve pipe?
I could get it to work using a plastic collar to connect pipe and cover. Would that be acceptable?

Any thoughts appreciated.

I have a photo if that would help but not sure how to put up.

Tom

Post: # 69888Post **msh paving** Mon Oct 31, 2011 6:32 pm

If you are using super sleve pipe you will need super sleve rodding eyes to fit correctly,super sleve is a size of its own,unless you use a jubilee clip clay adaptor and a short piece off 110mm plastic pipe MSH

Post: # 69894Post **seanandruby** Mon Oct 31, 2011 8:09 pm

should be able to get a stepped flexi coupling to adapt it.

haggistini · Post: # 69903Post **haggistini** Mon Oct 31, 2011 9:49 pm

Band seal I call um get you outta the shite every time