Bit of digging
-
- Posts: 20
- Joined: Thu Jan 06, 2011 11:45 am
- Location: Purley, Surrey.
-
- Posts: 2199
- Joined: Mon May 10, 2010 1:07 pm
- Location: Surrey
- Contact:
-
- Site Admin
- Posts: 4420
- Joined: Sat Aug 09, 2008 3:55 pm
- Location: high peak
- Contact:
Pile it up it with a dumper/ tracked barrow or just haymake it with machine?
It's an easy day if you're thinking of hire, take me about 2 hours with a micro depending on ground condition, but been driving machines 15 years.
Things that slow you down will be stiff ground, like dried out clay or dense chalk if I remember from previous post.
Moving the stuff with dumper etc
I get Assuming chalk at 15m3 so 22 tons dry or 36 tons wet and allowing for bulking.
Edited By GB_Groundworks on 1305564403
It's an easy day if you're thinking of hire, take me about 2 hours with a micro depending on ground condition, but been driving machines 15 years.
Things that slow you down will be stiff ground, like dried out clay or dense chalk if I remember from previous post.
Moving the stuff with dumper etc
I get Assuming chalk at 15m3 so 22 tons dry or 36 tons wet and allowing for bulking.
Edited By GB_Groundworks on 1305564403
Giles
Groundworks and Equestrian specialists, prestige new builds and sports pitches. High Peak, Cheshire, South Yorkshire area.
http://www.gbgroundworks.com
Groundworks and Equestrian specialists, prestige new builds and sports pitches. High Peak, Cheshire, South Yorkshire area.
http://www.gbgroundworks.com
-
- Posts: 20
- Joined: Thu Jan 06, 2011 11:45 am
- Location: Purley, Surrey.
Will probably need to move it a couple of metres because of the volume but was hoping to get away with haymaking for most.
Ground will be 40cm soil, thin layer of flint then chalk for last 30cm given prior digging. Got through 3m3 of it with a matlock so not too tough.
Given this if I do a 3 day hire over the long weekend should I be ok and have a bit of spare time for a bit of grading?
Ground will be 40cm soil, thin layer of flint then chalk for last 30cm given prior digging. Got through 3m3 of it with a matlock so not too tough.
Given this if I do a 3 day hire over the long weekend should I be ok and have a bit of spare time for a bit of grading?
-
- Site Admin
- Posts: 4420
- Joined: Sat Aug 09, 2008 3:55 pm
- Location: high peak
- Contact:
Yes
Giles
Groundworks and Equestrian specialists, prestige new builds and sports pitches. High Peak, Cheshire, South Yorkshire area.
http://www.gbgroundworks.com
Groundworks and Equestrian specialists, prestige new builds and sports pitches. High Peak, Cheshire, South Yorkshire area.
http://www.gbgroundworks.com
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire
-
- Posts: 1405
- Joined: Thu Sep 27, 2007 10:29 am
- Location: South Wales
- Contact:
-
- Posts: 1951
- Joined: Sat Dec 06, 2008 10:28 pm
- Location: Preston, Lancashire
-
- Posts: 20
- Joined: Thu Jan 06, 2011 11:45 am
- Location: Purley, Surrey.
Quick update - spent a nice couple of days with a K008 and got through the digging with no problems. Spent the first morning grading and removing the surplus earth in barrows filled by the digger. In the afternoon dug half of the pool hole, again moving the earth in barrows. Second day just used the digger to haymake the spoil into a big pile that I've since been moving round by hand in the evenings (in between down-pours...)
24 inch bucket with teeth got through the chalk at a fair rate. Definitely got the impression it would have been easier with a heavier machine but didn't have the access.
Most interesting moment was getting digger in and out - 73cm minimum clearance down the side of the house with the digger being 70cm. Had to lay a series of scaffolding board ramps and a seesaw to get up two flights of steps.
Cheers all, John
24 inch bucket with teeth got through the chalk at a fair rate. Definitely got the impression it would have been easier with a heavier machine but didn't have the access.
Most interesting moment was getting digger in and out - 73cm minimum clearance down the side of the house with the digger being 70cm. Had to lay a series of scaffolding board ramps and a seesaw to get up two flights of steps.
Cheers all, John
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire
well done john
sometimes i find the damage caused by machines does not merit their inclusion
if we dig by hand you can be sure of no collateral damage to patios ,lawns,brickwalls etc
it all depends how much digging
we took 15 8 yarder skips out of a garden in tring,with appalling access up stairs,did it in 3 weeks with 3 blokes
hard graft mind
LLL
sometimes i find the damage caused by machines does not merit their inclusion
if we dig by hand you can be sure of no collateral damage to patios ,lawns,brickwalls etc
it all depends how much digging
we took 15 8 yarder skips out of a garden in tring,with appalling access up stairs,did it in 3 weeks with 3 blokes
hard graft mind
LLL
-
- Posts: 1366
- Joined: Fri Apr 15, 2011 9:05 pm
- Location: Edinburgh
I prefer digging by hand. Keeps me fit :laugh:lutonlagerlout wrote:well done john
sometimes i find the damage caused by machines does not merit their inclusion
if we dig by hand you can be sure of no collateral damage to patios ,lawns,brickwalls etc
it all depends how much digging
we took 15 8 yarder skips out of a garden in tring,with appalling access up stairs,did it in 3 weeks with 3 blokes
hard graft mind
LLL
Whenever I hear people complain about being overweight, gym prices, not being able to get down to the gym etc I tell them to go in to their garden, dig a hole and fill it back in cool hand Luke style :laugh:
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire