Hi I'm new to the site and looking for advice and guidance please.
I've read most of the cutting in topics from the main site but my question is how do you mark out the slabs for cutting if you can't lay them down temporarily to mark them? My situation will be that my pathway will pass between a raised grass area (500mm high) and the garage. The grass side is a straight run but the garage is on an angle to the grass ie. not parallel so this is where my cuts will be, obviously i can't lay the slabs as the garage is in the way.
so any advice will assist me greatly
thanks
Clive :p
Marking out - How do you mark out for an awkward area
-
- Posts: 2598
- Joined: Wed Apr 08, 2009 8:01 am
- Location: Peoples Republic of Westhoughton
- Contact:
if the pieces are an awkward shape use cardboard or thick paper to make a template for each of the pieces then use this to draw round onto the flag, don't forget to allow for your joints
start with the largest pieces first so the template can be reused again and again as the pieces of flag go smaller and smaller
for some of the pieces of flags you may be able to use a tape measure if the pieces are in the shape of a triangle, measure one of the sides allowing for the width of the joint, lay the flag down flat and put the tape measure on the corner and mark the flag to your required length on this side
measure the other side also allowing for the width of the joint then mark your flag
join these 2 points together using a straight piece of timber or level and mark the flag so you have a straight line to work to and this will give you the size of flag you require
using an angle grinder or 2 stroke saw cut the flag, make sure your wearing your steel toecap safety boots, safety goggles and ear defenders
start with the largest pieces first so the template can be reused again and again as the pieces of flag go smaller and smaller
for some of the pieces of flags you may be able to use a tape measure if the pieces are in the shape of a triangle, measure one of the sides allowing for the width of the joint, lay the flag down flat and put the tape measure on the corner and mark the flag to your required length on this side
measure the other side also allowing for the width of the joint then mark your flag
join these 2 points together using a straight piece of timber or level and mark the flag so you have a straight line to work to and this will give you the size of flag you require
using an angle grinder or 2 stroke saw cut the flag, make sure your wearing your steel toecap safety boots, safety goggles and ear defenders
Crystalclear
Driveway and Patio Installer
Call us today
01942 840109
7 days a week 8am till 8pm
Driveways Patios and Paving Specialists
Driveways
Driveway and Patio Installer
Call us today
01942 840109
7 days a week 8am till 8pm
Driveways Patios and Paving Specialists
Driveways
-
- Posts: 3
- Joined: Sun Aug 01, 2010 1:51 pm
- Location: Rugby
mickg wrote:using an angle grinder or 2 stroke saw cut the flag, make sure your wearing your steel toecap safety boots, safety goggles and ear defenders
Thanks mickg
regarding your last line i've got all of those, i've even got slabs & cardboard. Just need the skill now.
I will be starting very soon so i'll keep you posted.
once again thanks.
Clive
-
- Posts: 1568
- Joined: Mon May 10, 2010 9:58 pm
- Location: Gatwick
- Contact:
-
- Posts: 3
- Joined: Sun Aug 01, 2010 1:51 pm
- Location: Rugby