Which grade indian sandstone to use?

Patio flagstones (slabs), concrete flags, stone flags including yorkstone and imported flagstones.
Post Reply
seandee
Posts: 7
Joined: Mon Jul 05, 2010 11:41 am
Location: berkhamsted

Post: # 50497Post seandee

Hi,
I'm putting a new patio in at my house and I've been researching different indian sandstone suppliers.
I've basically come up with 2 affordable options. One is uncalibrated stone 35-50mill thickness of varying slab size. The other is an economy grade 18-25mill thickness of varying size slab. The supplier says that the surface of both types looks good so it's based upon cost and usage.
The pation I'm laying isn't huge so cost wise there isn't much in it. Usage of the patio is to be restricted to people, and not that many as the space isn't that big.
One thought was that the economy slabs would be half the weight of the uncalibrated so therefore easier to handle (I'm laying it on my own).
Does anyone have any suggestions or has anyone used the economy grade stuff?

Thanks
Sean

Bob_A
Posts: 861
Joined: Wed Feb 27, 2008 9:30 pm
Location: SE London/ NW Kent

Post: # 50500Post Bob_A

Not sure if this will help but you could try reading this
http://ext.pavingexpert.com/cgi-bin....ibrated

seandee
Posts: 7
Joined: Mon Jul 05, 2010 11:41 am
Location: berkhamsted

Post: # 50503Post seandee

Thanks Bob that has helped. I'm going for the thicker slabs. For the sake of a few quid it's not worth the risk of going for the thinner ones.

When they were describing the mix for the thinner slabs they talked about making it slightly wet. Is that how I should go with the thicker slab or should I make it slightly dry? Also what sort of mix should I look at a 4:1? On the volume calculator it suggest 10:1, will that be strong enough?


Cheers
Sean

lutonlagerlout
Site Admin
Posts: 15184
Joined: Fri Aug 04, 2006 12:20 am
Location: bedfordshire

Post: # 50509Post lutonlagerlout

most of the lads on here would rather use a slightly stronger mix than 10:1 i usually do half a bag of cement to 14 grit sand which equates to around 6:1
i use a wetter mix than most,but if you use a drier mix then you will need to use a bond bridge
a slurry of SBR and neat cement painted on the underside of each flag
LLL
"what,you want paying today??"

YOUR TEXT GOES HERE

seandee
Posts: 7
Joined: Mon Jul 05, 2010 11:41 am
Location: berkhamsted

Post: # 50537Post seandee

Thanks for the advice LLL. I think I'll go with the 6:1, just wanted to make sure as i'm ordering the materials tomorrow.

Is grit sand sharp sand? And the 14 you refer to, is that shovel loads?

lutonlagerlout
Site Admin
Posts: 15184
Joined: Fri Aug 04, 2006 12:20 am
Location: bedfordshire

Post: # 50545Post lutonlagerlout

yes its shovel full ,but of course depends on the size of your shovel
grit sand is flooring or screeding sand
ask for sharp sand round here and you will get plastering sand
which is no good
LLL
"what,you want paying today??"

YOUR TEXT GOES HERE

seandee
Posts: 7
Joined: Mon Jul 05, 2010 11:41 am
Location: berkhamsted

Post: # 50568Post seandee

Thanks for the tip on the sand, could've been an annoying error.

Post Reply