Sealing a drive that's been done before - Acrylic coating

[Pro Drives]

Hi all

I've just typed a huge " Hello, this is me " type intro and promptly lost it by clicking the wrong button on my laptop.

So, I'll re-do that later , and crack on with the main issue.

I've been asked to clean and re-seal a drive. Previously done with Everbuilds 409 Blockguard,(a clear solvent based acrylic) according to the homeowner.

Everbuilds' tech help guy says the remaining non-worn coating has to be stripped off with Nitromors All Purpose ( non drip gel type )

I've tested in an out of the way area , and found that a healthy amount does indeed break it down , but a lightly coated brush "wiped" across a block until there's none on the brush dosn't make much of an impact.

If I have to liberally apply Nitromors it's going to be an expensive job.

My question is , can anyone recommend something to lift the Blockguard? I've searched , but am prepared to be pointed in the right direction if I've missed something.

Many thanks

Cheers

Pro Drives

[rab1]

Rogers the man your looking for R&A is the company name (I think). Only a guess but could you not use a high temp power washer ???

[Pro Drives]

Hi

Thanks for the reply. I'm aware of R&G and Amogen from reading the board, but , being new I thought I'd let them answer if they wish , rather than pestering them via email.

I thought that hot water might be the answer, however I've only got cold on tap..........................

Cheers

PD

[rab1]

most of these power washers are kerosene fueled and produce their own heat, the secrets not to drop the temp.

[Amogen]

If you want to give me a call, feel free. The number is on my website.... You can call tonight if you wish, but dont make it too late!!!

[Pro Drives]

If you want to give me a call, feel free. The number is on my website.... You can call tonight if you wish, but dont make it too late!!!

Thanks Andy, nice talking to you.

[Amogen]

Thanks Andy, nice talking to you.

Your welcome. Any more questions or problems, just give me a call.

[lutonlagerlout]

i feel excluded now
LLL

[Amogen]

i feel excluded now
LLL

Awwwww

Pro Drive, we ought to do a conference call next time....

[lutonlagerlout]

i thought the whole point of this forum was to share techniques and ideas
LLL

[seanandruby]

......ditto ???

[rab1]

apologise Andy, forgot all about you. wont happen again mate.

[Amogen]

Guys,

The chat we had was just a general chat about life as a driveway and patio cleaner!!! Noting really in depth was discussed. If there was anything regarding the original post that would be of assistance to the first post, i would have typed it out for future reference.....

[Pro Drives]

i feel excluded now
LLL

OMG , first thread on this board and I've upset the reglars.Apologies all round

I thought I might get flamed for asking a question that's been put a brazilian times before, so for a member to offer to take a phone call was too good a chance to pass over.

Anyway , I'll have loads more questions, no doubt , and welcome any and all responses , serious and sarky , 'cause I do like a bit of banter

:;):

Cheers

PD

[lutonlagerlout]

no offence taken PD,was just seeing if you bit
any sane questions we will always try and answer
welcome to the brew cabin
LLL