Flowpoint rapid setting grout - Jointing compound
-
- Posts: 661
- Joined: Mon Feb 21, 2005 11:54 am
- Location: Birmingham, west midlands, UK
- Contact:
Been using a new , to me anyway, product for jointing our Paving, sett and cobbles called "Flowpoint rapid setting grout" by Instarmac. Comes in a 25kg bag, keeps well when opened and can be used to patch if you need to repair a section later. you mix it with apaddle bag at a time and just pour it into your joints, like a slurry and then, depending on temperature, hoes it off in approx 15-20 mins. You can get along in medium rain if needed and sets to vehicle strength in 4 hours. We've found it great, especially with setts. Found it's best to try and leave a slurry pit to make clean up after easier, and we apply it from a jug to control flow better but pretty reasonable cost to. A 25kg in grey is about 9.50 with the vat, covers approx 10m2 depending on joint size and width, paving that is, setts are a bit different.
Gi it sum ommer
-
- Posts: 1071
- Joined: Sat Aug 22, 2009 8:57 pm
- Location: essex
-
- Posts: 661
- Joined: Mon Feb 21, 2005 11:54 am
- Location: Birmingham, west midlands, UK
- Contact:
good gear, and they do a few colours now. Their local to us so we just go and get what we need. I've just missed an open day and they've got a few other products for paving. We first used it in september on a rare warm sat morning. Turned our backs to down a coffee while we allowed it to set and 10 mins later we couldn't shift off the face of the setts. only about 5m2, learned to keep a fine mist spray on it now. but I recommend to give it a try
instarmac; 01827 872244 Tamworth staffs
instarmac; 01827 872244 Tamworth staffs
Gi it sum ommer
-
- Posts: 1071
- Joined: Sat Aug 22, 2009 8:57 pm
- Location: essex
-
- Posts: 661
- Joined: Mon Feb 21, 2005 11:54 am
- Location: Birmingham, west midlands, UK
- Contact: