New drains on extension - How to fit

[keithklj]

Hi i need help i have just built a new extension my dpc is quite low ie its about 12 inches above the the footing which naturally pretrudes from the wall by about 6 inches i need to put a drain in along this wall to take the waste from the kitchen my problem is all the traps are quite deep i need to keep it level with the path which will run down beside the building but as i need this path to be at least 6 inches below the dpc im a bit stuck do i have to come beyond the footing to drop the trap down or is there another way round it. hope this makes sense i will try to draw a picture and attach it tomorrow
THANKS

[seanandruby]

yes pic would be nice. you can put the traps at any height with raising pieces. you may need slow bends to come up and over the founds.

[lutonlagerlout]

you may have to kango a bit of the foundation to allow the gully to sit flush to the wall
LLL

[keithklj]

Hi thanks for your replies wasnt sure if i was allowwed to cut a bit of the footing away. Ill attach some pics if someone tells me how to please

[Dave_L]

Gunning the founds out on the edges to fit drainage will be fine as has been said - we've done it plenty of times when required.

Uploading pictures? This will help.

Photos

[keithklj]

thanks that helps i think when connecting into the exsisting ic do i have to break through as low down as poss? i will be going into another ic at the change of direction my exsisting ic is about 4 foot deep
that photo things sounds really complicated not sure i can get them up on here a bit beyond me