Concrete ramps - Making a ramp at a garage entrance
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire
remove old ramp
make shutter 45-600 mm out from the garage and the width of the door place this in position and hold in place with lamp irons
make sure you have at least 150 of concrete beneath finished level,this may involve dogging some more out.
then using a fairly stiff concrete fill the void ,building your slope in as you go
once its all in screed off of your shutter then let it go off a bit.
trowel it up smooth with a square finishing trowe,then use a soft hair brush to brush it parallel to the door.
finally trowel 100m smooth around the edges of the shutter
dont let rain get on it and no cats or kids
cheers LLL
make shutter 45-600 mm out from the garage and the width of the door place this in position and hold in place with lamp irons
make sure you have at least 150 of concrete beneath finished level,this may involve dogging some more out.
then using a fairly stiff concrete fill the void ,building your slope in as you go
once its all in screed off of your shutter then let it go off a bit.
trowel it up smooth with a square finishing trowe,then use a soft hair brush to brush it parallel to the door.
finally trowel 100m smooth around the edges of the shutter
dont let rain get on it and no cats or kids
cheers LLL
-
- Site Admin
- Posts: 4732
- Joined: Fri Jul 28, 2006 8:47 pm
- Location: Somerset
- Contact:
Love the cats and kids get out at the end Tony!
RW Gale Ltd - Civils & Surfacing Contractors based in Somerset
See what we get up to Our Facebook page
See what we get up to Our Facebook page
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire