Unearthing and burying utility pipes...
-
- Posts: 29
- Joined: Sun Apr 09, 2006 8:16 pm
- Location: St Annes
Oops does this need to be in Siteworks?
I've just started digging the foundations for my new driveway and so far i've unearthed one lead pipe and another rather ugly rusty looking pipe that looks like some of the metal work you'd currently see on the titanic.
Can anybody tell me if it's ok just to recover these with MOT or should they be protected in any way before being buried again?
P.S. Just ordered a copy of Driveways, Paths and Patios A Complete Guide to Design Management and Construction by Tony McCormack, which i heard about from looking at this site. At £11.21 from WH Smiths online it's a bargain.
I also did this last year for my first block paving attempt...
Cost me £1060 for everything. There's a good sized bit off the picture.
I've just started digging the foundations for my new driveway and so far i've unearthed one lead pipe and another rather ugly rusty looking pipe that looks like some of the metal work you'd currently see on the titanic.
Can anybody tell me if it's ok just to recover these with MOT or should they be protected in any way before being buried again?
P.S. Just ordered a copy of Driveways, Paths and Patios A Complete Guide to Design Management and Construction by Tony McCormack, which i heard about from looking at this site. At £11.21 from WH Smiths online it's a bargain.
I also did this last year for my first block paving attempt...
Cost me £1060 for everything. There's a good sized bit off the picture.
-
- Posts: 308
- Joined: Sat May 27, 2006 9:19 pm
- Location: cheadle uk
if it a lead water pipe its going to be the main and i would replace it while u have the ground open as it where. u don't wont to be drinking lead
and the "steal" (cast iron)? pipe might well be gas but don't quote me on that and i am libel to be shot down in fames bunt a nice jacket of concrete will probably do z job all thought it depend on how close the top of the mot the pipe is
a pic might help
andy
and the "steal" (cast iron)? pipe might well be gas but don't quote me on that and i am libel to be shot down in fames bunt a nice jacket of concrete will probably do z job all thought it depend on how close the top of the mot the pipe is
a pic might help
andy
Warning "Dyslexic Fingers At Work" in Cheadle, Manchester UK
cheers andy
cheers andy
-
- Site Admin
- Posts: 4732
- Joined: Fri Jul 28, 2006 8:47 pm
- Location: Somerset
- Contact:
Burying the pipework in type 1 will be just fine.
Can you put up a picture of these pipes?
Sound like gas and water....gas service would be approximately 35mm in diameter.
Can you put up a picture of these pipes?
Sound like gas and water....gas service would be approximately 35mm in diameter.
RW Gale Ltd - Civils & Surfacing Contractors based in Somerset
See what we get up to Our Facebook page
See what we get up to Our Facebook page
-
- Posts: 29
- Joined: Sun Apr 09, 2006 8:16 pm
- Location: St Annes
Morning all,
I've taken some pictures this morning. The lead pipe is just 12 inches below ground level and the other rusty looking pipe is about 2' down. Does this mean the lead pipe is gas as when the house was built I imagine they won't have had gas.
The excavations are deep as after the house foundations were put in the holes were backfilled with sand from the local sand dunes. It's nice and easy to dig out though!
I've taken some pictures this morning. The lead pipe is just 12 inches below ground level and the other rusty looking pipe is about 2' down. Does this mean the lead pipe is gas as when the house was built I imagine they won't have had gas.
The excavations are deep as after the house foundations were put in the holes were backfilled with sand from the local sand dunes. It's nice and easy to dig out though!
-
- Site Admin
- Posts: 4732
- Joined: Fri Jul 28, 2006 8:47 pm
- Location: Somerset
- Contact:
Pic 1 - if you follow the line of the pipe to the house, does it conincide with a water or gas service coming up through the floor somehwere in the house? I've often found that to be a good guide. Also, go the other way - look out into the street and see if any access covers/stop cocks are roughly in line with it.
RW Gale Ltd - Civils & Surfacing Contractors based in Somerset
See what we get up to Our Facebook page
See what we get up to Our Facebook page
-
- Posts: 29
- Joined: Sun Apr 09, 2006 8:16 pm
- Location: St Annes
Well both pipes start in a similar place under the front wall. The stop cock for the water is round the back in the kitchen as I had to put a new one in when I replaced the kitchen. Where the pipe enters the house it is lead (Pre stop cock).
However there is a patch in the concrete on the driveway down the side where the gas meter is on the other side of the wall...
I don't suppose it matters really which is which. So if I cover them in either concrete of MOT they should be ok?
Thanks for your advice guys.
However there is a patch in the concrete on the driveway down the side where the gas meter is on the other side of the wall...
I don't suppose it matters really which is which. So if I cover them in either concrete of MOT they should be ok?
Thanks for your advice guys.
-
- Site Admin
- Posts: 4713
- Joined: Mon Jun 26, 2006 11:01 am
- Location: eastbourne
-
- Posts: 10
- Joined: Sat Mar 31, 2007 2:49 pm
- Location: devon england
the service's should be re-instated with sand, 250mm above the crown of the service and hand tamp for compaction then continue with back filling with gsb1 at the correct layer thickness and compaction rate, really also would be wise to lay some identifaction tape above the service in case of future excavation's
Affordable Drainage Engineers
-
- Site Admin
- Posts: 4732
- Joined: Fri Jul 28, 2006 8:47 pm
- Location: Somerset
- Contact:
If only everybody did that it'd make our lives so much easier!
Would be nice if the utilities got their services down at the correct depth too!
Would be nice if the utilities got their services down at the correct depth too!
RW Gale Ltd - Civils & Surfacing Contractors based in Somerset
See what we get up to Our Facebook page
See what we get up to Our Facebook page
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire