Whacker plate - Whacker plate with no rubber base

All forms of block paving, brick paving, flexible or rigid, concrete or clays, new construction or renovation
Post Reply
morayr6
Posts: 4
Joined: Thu May 04, 2006 10:45 am
Location: scotland

Post: # 12215Post morayr6

Hello Tony, I have been lucky enough to get a loan of a whacker plate for finishing my drive to new garage, approx 21 sqm. This is to be finished off in Marshalls Driveline 50 Brindle. The whacker plate does not have a rubber base to protect blocks when final whacking. Can I use a decent sized piece of wood under whacker and move it as required, such as plywood.

Ian CHP
Posts: 17
Joined: Wed Nov 16, 2005 8:29 pm
Location: Wincham
Contact:

Post: # 12216Post Ian CHP

What you need is either
a) A boat load of silica sand to cover the area and stop the plate smashing nine bells out of the paving

b) A piece of carpet(not foam) strapped to the plate

or my personal favourite at the moment

c) A ton bulk bag, fold it up and use the lifting straps to fasten it to the plate.

The key to the plate is that it compacts, but doesnt bounce and take the face of the blocks. If you use timber it will bounce like a bronco.

On the subject of wacker plates mines just departed this world, if anyone has one going cheap, i'd be interested :(

morayr6
Posts: 4
Joined: Thu May 04, 2006 10:45 am
Location: scotland

Post: # 12219Post morayr6

Hey the tonne bag sounds favourite as I will have at least one spare before whacking when I fill the 21sqm void with sharp sand. I wouldnt have thought of that one. Thanks again :)

Nigel Walker
Posts: 190
Joined: Sun Aug 22, 2004 7:28 pm
Location: Cumbria
Contact:

Post: # 12226Post Nigel Walker

I have never used a rubber mat when compacting Marshalls Driveline 50. Had no problems with scuffing or marking the blocks.
Only problem with the Driveline 50 blocks is the strength and quality. On an average 60m2 drive I was getting about 10 broken blocks that needed replacing after sanding and compacting. This was annoying as once a block has been sanded and compacted it takes a bit of removing, thus adding wasted time to a job.
I have been using Tobermore blocks for the past 18 months (about 60 jobs) and have not had a single broken block.
Another thing with the Driveline 50 blocks - in a pack of 488 blocks you will have approx. 20 - 30 broken ones that cannot be laid or need to be used for cuts. To me this is not acceptable.

morayr6
Posts: 4
Joined: Thu May 04, 2006 10:45 am
Location: scotland

Post: # 12228Post morayr6

Hello Nigel, I actually bought one pallet of Marshalls Driveline 50, I already had over 1000 Marshalls driveline 60, but I couldnt source the 60mm to finish drive so had to go with 50mm. Anyway thanks for the advice I wont chance using bare whacker on the blocks, will try the bag. But if it keeps coming off will use bare whacker.

LuckyPants
Posts: 30
Joined: Tue May 13, 2003 3:32 pm
Location: North Wales

Post: # 12287Post LuckyPants

My local hire center will rent out the rubber mat for a wacker @ £2.00 a day. No need to hire the wacker as well. Why not try a couple of hire centers to see if you can get a mat? Shame to spoil the job if your temporary solution fails and you take the face off the block.

Post Reply